Fuji Xerox DocuPrint P505 d

Connecting and Setting Up Your Printer
21
Setting Up the Printer (Printer Setup)
2
Note

The optional Wireless LAN Kit must be installed on the printer.
 WPS-PBC
You can start Push Button Configuration only from the control panel.
1 Press the Home button.
2 Tap [Device] > [Connectivity] > [Wi-Fi].
3 Tap [Manual Setup].
4 Tap [Wi-Fi Protected Setup (WPS)] > [PBC] > [OK].
Note

Start the WPS-PBC on the wireless LAN access point (Registrar) within 2 minutes.
When the WPS operation is successful and the printer is rebooted, wireless LAN connection
setting is completed.
 WPS-PIN
The PIN code of WPS-PIN can only be configured from the control panel.
1 Press the Home button.
2 Tap [Device] > [Connectivity] > [Wi-Fi].
3 Tap [Manual Setup].
4 Tap [Wi-Fi Protected Setup (WPS)] > [PIN].
5 Write down the displayed 8-digit PIN code for the wireless LAN access point.
6 Tap [OK].
Note

Enter the PIN code into the wireless LAN access point (Registrar) within 2 minutes.
When the WPS operation is successful and the printer is rebooted, wireless LAN connection
setting is completed.
 Auto SSID Setup
1 Press the Home button.
2 Tap [Device] > [Connectivity] > [Wi-Fi].
The printer automatically searches the access points on wireless network.
3 Tap the desired access point.
When you select an access point with no encryption, proceed to step 5.
If the desired access point does not appear, go to "Manual SSID Setup" (P.22).
Note

Some hidden SSID may not be displayed. If the SSID is not detected, turn on SSID broadcast from the router.