System expansions
A26361-K678-Z121-1-7619, edition 1 43
Installing a hard disk drive
► Take the new hard disk drive out of its packaging.
► Make the required settings (e.g. master/slave, cable select) on the drives.
► Secure the EasyChange rails on the side of
the hard disk by inserting the upper pins of
the EasyChange rail in the corresponding
holes of the hard disk.
► Connect the cables to the hard disk drive.
2
1
1
► Press the EasyChange rails mounted on the hard
disk drive together somewhat (1) and slide the
hard disk drive into the case in the direction of the
arrow (2).
► Close the casing (see "Closing the casing").
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
EasyChange rails for a second hard disk drive are mounted on the drive cage.
To Next Page
Loading...
Need help?
General
