Fujitsu Siemens Computers SCENIC Edition X100 User Manual

System expansions
44 A26361-K678-Z121-1-7619, edition 1
Installing/removing hard disk drive with screws
i
This chapter only applies to the SCENIC Edition X100.
On the SCENIC Edition X100 the hard disk drive can only be mounted in the second bay
with screws.
Removing a hard disk drive
► Open the casing (see "Opening the casing").
► Unscrew the four screws (1) on the drive cage.
► Pull the second hard disk drive out of the casing in the direction of the arrow (2).
► Disconnect all cables connected to the drive (data cable, power supply cable).
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
► Connect the cables to the hard disk drive.
► Close the casing (see "Closing the casing").

Fujitsu Siemens Computers SCENIC Edition X100 Specifications

General

Brand	Fujitsu Siemens Computers
Model	SCENIC Edition X100
Category	Desktop
Language	English