Fujitsu Siemens Computers SCENIC Edition X100 User Manual

System expansions
42 A26361-K678-Z121-1-7619, edition 1
Installing/removing hard disk drive with EasyChange rails
i
This chapter only applies to the SCENIC Edition X100.
On the SCENIC Edition X100 the hard disk drive can be secured in the first installation
bay with EasyChange rails.
The second hard disk drive o the SCENIC Edition X100 can only be installed with screws
(see "Installing/removing hard disk drive with screws").
► Open the casing (see "Opening the casing").
Removing a hard disk drive
2
1
1
► Press the EasyChange rails mounted on the hard disk drive together somewhat (1) and pull
the hard disk drive out of the case in the direction of the arrow (2).
► Disconnect all cables connected to the drive (data cable, power supply cable).
► Pull the EasyChange rails off the hard disk
drive.
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
► Connect the cables to the hard disk drive.
► Close the casing (see "Closing the casing").

Fujitsu Siemens Computers SCENIC Edition X100 Specifications

General

Brand	Fujitsu Siemens Computers
Model	SCENIC Edition X100
Category	Desktop
Language	English