- (01 - 28) -
WALL MOUNTED TYPE
ASTG18-24KMCA
WALL MOUNTED TYPE
ASTG18-24KMCA
REMOTE CONTROLLER CUSTOM CODE SETTING
Use the following steps to select the custom code of the remote controller. (Note that
the air conditioner cannot receive a custom if the right custom code has not been set.)
(1) Press the START/STOP ( / ) button until only the clock is displayed on the
remote controller display.
(2) Press the MODE button for at least 5 seconds to display the current custom code
(initially set to ).
(3) Press the SET TEMP. ( / ) buttons to change the custom code between
→ → → .
Match the code on the display to the air conditioner custom code.
(4) Press the MODE button again to return to the clock display. The custom code will
be changed.
If no button is pressed within 30 seconds after the custom code is displayed, the system returns to the original
•
clock display. In this case, start again from step (1).
The air conditioner custom code is set to A prior to shipment.
•
To Next Page
Loading...
Need help?
General
