System expan sio ns
► Secure the EasyChange rails on the side of the hard disk by inse rting the upper pins
of the EasyChange rail in the corresponding holes on the hard disk.
By default, th e wiring for standa rd installation (max. four 2
1
/
2
-inch drives) is installed.
If you wish to install other or different drives, use the supplied cables.
1
► Slide the hard disk drive with the EasyChange rails into the drive cage in the direction of the
arrow (1). Ensure that the label on the 3½" hard disk drive is fa cing the side cover to be opened.
If you are installing a 2½" hard disk drive, ensure that the label is on the top.
► Connect the cables to the hard disk drive.
Fujitsu Technology Solutions 55
To Next Page
Loading...
