System expansions
► For PCI boards: Install the card holder on the fro nt fan again (see
"
Install ing the front fan", Page 48).
► C lose the casing (see "
Closing the casing", Page 35).
If you have installed or removed a board, please check the relevant slot
settings in the BIOS Setup. If necessary, change the settings. Further
information is provided in the board documentation.
Removing a board
► Open the casing (see "Opening the casin g", Page 34).
Board
► D isconnect the cables connected to the bo ard.
► For PCI boards: R emove the card holder on the front fan so that you can click the board
into place on the front fan (see "
Removing the front fan", Page 43).
1
2
► Push the retaining clip (1 ) towards the slot c over to unlock it, then move
it towards back panel of the device.
► Pull the board out of t he s lot in the direction of the arrow (2).
► Place the board in suitable packaging.
60 Fujitsu Technology Solutions
To Next Page
Loading...
