System expan sio ns
1
2
► Push the retaining clip (1) towa rds the slot cover to unlock it, then move
it towards the b ack panel of the device.
► Pull the slot cover out of the slot in the direction of the arrow (2).
Do not throw away the slot cover. For cooling, protection against fireandinorderto
comply with EMC regulations, you must refit the slot cover if y ou remove the board.
2
1
► Push the board into the slot (1).
► Swivel the retaining clamp back again until you feel it click into place (2).
► Connect the ca bles to the board.
► For display adapters with additional power supply: Attach the display adapter
power cable to the power supply.
Fujitsu Technology Solutions 59
To Next Page
Loading...
