EasyManua.ls Logo

Fujitsu ESPRIMO P15 Series - FCC Class B Compliance Statement

Fujitsu ESPRIMO P15 Series
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Importan t notes
FCC Class B Compliance Statement
The following statement applies to the pro duct s covered in this manual, unless otherwise specied
herein. The statement for other products will a ppear in the accompanying documenta tion.
NOTE:
This equipment has been tested and found to comply with the limits for a "Class B" digital
device, pursuant to Part 15 of the F CC rules and meets all requirements of the Canadia n
Interference-Causing E quipment Standard IC E S-003 for digital apparatus. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate r adio frequency ene rgy and, if not installed
and used in strict accorda nce with the instructions, may cause harmful inte rference to radio
communications. However, there is no gu arantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Fujitsu Technology Solutions GmbH is not responsible for any radio or television interference
caused by unauthorized modications of this equipment or the substitution or attachment
of connecting cables and equipment other than those specied by Fujitsu Technology
Solutions GmbH. The correction of interferences caused by such unauthorized modication,
substitution or attachment will be the responsibility of the user.
The use of shielded I/O cables is required when connectin g this equ ipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC and ICES rules.
10 Fujitsu Technology Solutions

Table of Contents

Related product manuals