Fujitsu ESPRIMO P15 Series - The Device Cannot be Switched off with the ON;OFF Switch; Monitor Remains Blank

Troubleshooting and tips
The device cann ot be switch ed off with the O N/OFF switch.
Cause
Remedy
The device has not been switched on with the
ON/OFF switch.
► Press the ON/OFF switch again.
System crash ► Keep the on/off switch pressed for at least 4
seconds until the machine switches off.
Caution: This can lead to a loss of data!
This procedure does not allow the operating
system to shut down in an orderly way. The next
time the system is started there may well be
error messages.
Monitor remains blank
Cause
Remedy
Monitor is switched off. ► Switch your monitor on.
Power saving has been activated (screen is
blank)
► Press an y key on the keyboard.
or
► Deactivate the screen s a v er. If
necessary, enter the appropriate
password.
Brightness control is set to dark ► Adjust the brightn ess control. Fo r detailed
information, plea se refer to the operating
manual supplied with your mon itor.
Power cable not connected
► Switch off the monitor and the device.
► Check that the monitor power cable is
properly connected to the monitor and to
a groun ded mains outlet or to the monitor
socket of the device.
► Check that the device po wer cable is
properly plugged into the device and a
grounded mains outlet.
► Switch on the monitor and the device.
Monitor cable not connected
► Switch off the monitor a
nd the device.
► Check that the monitor cable is properly
connected to the device and monitor.
► Switch on the monitor an
d the device.
26 Fujitsu Technology Solutions