Getting started
Connecting the device to the mains supply
Mainsadapt er
2
1
► Connect the power cable to the device (1).
► Plug the power plug into a grounded mains outlet (2).
Switchingonforthefirst time: installing the software
Installing,Software,Installing,
Once the installation has been started the d e vice m ust no t be switched
off, unless the insta llation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out corre ctly and the contents
of the hard disk m ust be completely restored.
If the device is integrated into a network, the user and server details as well as
the network protocol are required during the software installation.
Contact you r network administrator if you have any questions about these settings.
When you switch on the device for the first time, the s upplied s oftware
is installed and con fig ured. Plan a reasonable amount of time for this,
as this process must not be interrupte d.
You m ay need the licence number for W indows during the installation. The licence
number is located on a sticker on your device.
Fujitsu Technology Solutions 17
To Next Page
Loading...
