Getting started
Connecting a monitor
► Follow the instructions contained in th e monitor manu al to prepare the monitor
for operation (e.g. connecting cables).
Monitor
► Connect the data cable of the monitor into the monitor port of your device.
The monitor power cable may on ly be connected to the de vice monitor socket if
the monitor current consumption is less than 1.5 A for 230 V or 3 A for 115 V.
The v alues for the monitor current consump tion can be found in the technical
data on the monitor or in the operating manual for the monitor.
► Depending on the configuration level of your device, plug the monitor power
cable into the grounded mains outlet.
Connecting the mouse
Depending on the equipment level selected, your device will be supplied with
a U SB mouse or a PS/2 mouse.
Mouse,Connecting,
Connecting a USB mouse
► Connect the USB mouse to one of the USB ports on the device.
USBport,USBp ort
Connecting a PS/2 mouse
If you do not attach a mouse to the PS/2 mouse port, you can disable the mouse
controller in the BIOS Setup in order to free the IRQ 12 for a d ifferent application.
► Connect the PS/2 mouse to the PS/2 mouse po rt of the device.
PS/2mouse,Connecting,PS/2mouse,
Connecting the keyboard
Depending on the equipment level selected, your device will be supplied with
a USB keyboard or a PS/2 keyboard.
Keyboard,Connecting,
Connecting a USB keyboard
Use the supplied keyboard cable only.
USBport,Connecting,
► Plug the rectangular connector of the keyboard cable into the rectangular socket
on the underside or on the rear of the keyboard.
► Insert the flat rectang ular USB plug of the keyboard cable into one of the d evice’s USB ports.
USBpor
t
Connecting a PS/2 keyboard
Use the supplied keyboard cable only.
ConnectingaPS/2keyboardConnecting,
► Plug the rectangular connector of the keyboard cable into the rectangular socket
on the underside or on the rear of the keyboard.
► Plug the round plug of the keyboard cable into the keyboard port on the device.
Keyboard,
Fujitsu Technology Solutions 15