Important notes
Important notes
ImportantnotesNotes
In this chapter you will find information regarding safety which it is essential to
take note of when working with y our device.
Safety information
SafetyinformationNote
Payattentiontotheinfo
rmation provided in the "Safety" manual
and in the following safe
ty notes.
When installing and ope
rating the device, please observe th e no tes on
environmental conditi
ons in Chapter "
Technical specification", Page 45 as well
as the instructions in C
hapter "
Getting started", Page 11.
When setting up the dev
ice, make sure there is clearance all aroun d it so that
thecasingreceives
enough ventilation. In order to avoid overheating, do not
cover the ventilati
on areas of the monitor or the device.
You must only opera
te the device if the rated voltage used by the
device is set to the
local mains voltage.
Check the rated vol
tage set for this device (see "
Getting started", Page 11).
The main switch (i
f present) and the ON /O FF switch do not disconnect the
device from the ma
ins voltage. To completely d isconnect from the mains
voltage, remov
e the power plug from the powe r socket.
Replace the lit
hium battery on the mainboard in accordan ce with the instru ctions
in "
Replac ing t
he lithium battery", Page 44.
Caution, comp
onents in the system can get very hot.
The activiti
es described in these instructions must always be
performed wi
th the greatest care.
Repairs to th
e device must only be carried out by qualified technicians. Incorrect
repairs cou
ld put the user at great risk (electric shock, hazardous energy emissions,
risk of fire
) or cause serious damage to the equipment.
Transpor
ting the device
Device,Transp o
rtation
Retrans
portation
Transport all parts separately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack th em u ntil all transportation manoeuvres are completed.
If the device is broug ht from a cold environment into the room whe re it will be used,
condensation may occur. Before operating the device, w ait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
Fujitsu Technology Solutions 7
To Next Page
Loading...
