EasyManua.ls Logo

Fujitsu ESPRIMO P372 Series - FCC Class B Compliance Statement

Fujitsu ESPRIMO P372 Series
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Important notes
FCC Class B Compliance Statement
The following statement applies to the products covered in this manual, unless otherwise specied
herein. The statement for other products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a "Class B" digital
device, pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian
Interference-Causing Equipment Standard IC E S-003 for digital apparatus. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency ene rgy and, if not installed
and used in strict accordance with the instructions, may cause h armful interference to ra dio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can b e determined by turning the equipment off and on , the user is encouraged to
try to correct the interference by one or m ore of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Fujitsu Technology Solutions GmbH is not responsible for any radio or television interference
caused by unauthorized modications of this equipment or the substitution or attachment
of connecting cables and equipment other than those s peci ed by Fujitsu Technology
Solutions G m bH. The correction of interferences caused by such unauthorized modication,
substitution or attachment will be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC and ICES rules.
10 Fujitsu Technology Solutions

Table of Contents

Related product manuals