System expansions
System expansions
Upgrades,Device,SystemexpansionComponentsServicing
Repairs to the device must only be carried out by qualified technicians.
Unauthorised opening or incorrect repair may greatly endanger the user (electric
shock, fire risk) and will invalidate your warranty.
After consulting the Hotline/Service Desk, you may remove and install the
components described in this manual yourself.
If you remove or install components without co nsulting the Ho tline/Service
Desk, then the warranty o f your device will become void.
As the device has to be shut down in order to install/deinstall system hardw are
components, it is a good idea to print out the relevant sections of this chapter bef orehan d.
The following illustrations may differ slightly from your device, depe nding on its configuration level.
If further docu mentation was delivered with your device, plea se also read this through carefully.
In addition, before removing or installing system components, please pay attention to the following:
The device must be switched off when installing/removing the system
expansions and may not be in energy-saving mode.
Remove the power plug before opening the device.
Be careful that no wires become trapped when removing or installing components.
When installing components th at become very hot, make sure that the
maximum permissible temp erature is not exceeded.
An update of the BIO S may be required for a system expansion or hardware
upgrade. Further information can be found in the BIOS help section or if
necessary in the Technical Manual for the mainboard.
30 Fujitsu Technology Solutions
To Next Page
Loading...
