System expansio ns
Do not throw away the slot cover. For cooling, protection against fireandinorderto
comply with EMC regulations, you must refit the slot cover if you remove the board.
2
1
► Push the board in
to the slot (1).
► Tighten the screw on the slot cover (2).
► Secure the cove
r plate on the casing again.
► If necessary, connect the cables to the board.
► Close the casi
ng (see "
Closing the casing", Page 33).
If you have in
stalled or removed a board, please check the relevant PCI
slot setting
sintheBIOS Setup. If necessary, change the settings. Further
informatio
n is provided in the PCI board do cume ntation.
Fujitsu Technology Solutions 35
To Next Page
Loading...
