Getting s tarted
Setting up the device
Workstati onErgonomicDevice
When installing your device, please read the recommendations and safety
notes in the "Safety/regulations" manual.
We recommend that yo u place your device on a surface which is not slippery. In
view of the m an y different fin ishes an d varnishes used on furniture, it is possible
that the rubber feet will mark the surface they stand on.
Depending on the location of your device, bothersome vibrations and noises may
occur. To prevent this, a distance of at least 10 mm / 0.39 inch should be maintained
from other devices on casing sides without ventilation s urfaces.
In order to avoid overheating, do not cover the ventilation areas
of the monitor or the device.
A minimum distance of 200 mm / 7.87 inch from the device must
be observed for ventilation areas.
Do not stack several devices on top of each other.
Do not expose the device to extreme ambient conditions (see "
Tech nical
spec ification", Page 44, section "Ambient conditions"). Protect the
device against dust, humidity and heat.
Operating po s iti
on
Use the device on
ly in the vertical operating position.
Connecting the device to the mains supply
Mainsadapt er
2
1
► Conn
ect the power cable to the device (1).
► Plug the power plug into a grounded mains outlet (2).
12 Fujitsu
To Next Page
Loading...
