Fujitsu ESPRIMO P4 Series - Connecting the Keyboard; Connecting External Devices to the Serial Interface

Getting s tarted
Connecting the keyboard
You can connect a USB keyboard or a PS/2 keyboard to your device .
Keyboard,Connecting,
Connecting a USB keyboard
Use the supplied keyboard cable only.
USBport,Connecting,
► Plug the rectangular connector of the keyboard cable into t he rectangular socket
on the underside or on the r ear of the keyboard.
► Insert the flat rectangular USB plug of the keyboard cable into one of the device’s USB ports.
USBport
Connecting a PS/2 keyboard
Use the supplied keyboard cable only.
Connectinga PS/2keyb oardConnecting,
The PS/2 keyboard is only detected by the device if you connect the keyboard
when the device is s witched off and then switch the device on again.
► Switch your device off.
► Plug the rectangular connector of the keyboard cable into t he rectangular socket
on the underside or on the r ear of the keyboard.
► Plug the round plug of the keyboard cable into the keyboard port on the device.
Keyboard,
► Switch your device on again.
Connecting external devices to the serial interface
SerialinterfaceSerialinterface,Externaldevices,Devices,
External devices can be connected to the serial interface (e.g. a printer or modem).
► Connect the data cable to the external device.
► Connect the data cable to the corresponding serial interface.

For an exact description of how to connect ext ernal devices to the corresponding
port, please see the external device documentation.
Port settings
Serialinterface,
You can change the port s ettings (e.g. address, interrupt) in the BIOS Setup.
Device drivers
Devic
edri vers,
The devices conn ected to the serial interface require drivers. Your operating system
already includes many drivers. If the required drive is missing, install it. The latest
drivers are usually available on the Internet or will be supp lied on a da ta carrier.
16 Fujitsu