Troublesho ot ing and tips
Troubleshooting and tips
Refer to the safety notes in the "Safety/regulations" m anual and in the "Getting
started", Page 11 chapter when connecting or disconnecting cables.
If a fau lt occu rs, try to c
orrect it as described in the following documentation:
• in this chapter
• in the documentation for t he conn ecte d devices
• in the help systems of th
e s oftwar e used
• in the documentation for your operating system
Help if problems occur
Should you encount
er a p roblem with your computer that you can not resolve yourself:
► Note the ID number
of your device. The ID number is found on the type rating
plate on the back,
the underside o r the top of the casing.
► For further clarification of the problem, contact the Service Desk for your country (see the
Service Desk list or visit the Internet at "
http://suppo r t.ts.fu jitsu.com/contact/servicedesk"). When
you do this, please have r eady the identity number and serial number of your system.
Troubleshooting
Power indicator remains off afte r you have switched
on your device
Cause
Remedy
The mains voltage supply is faulty. ► Check that the power cable is correctly
plugged into the device and into a grounded
mains outlet.
► Check that the main switch at the rear of the
monitor is set to the "I" position.
► Switch the device on.
Internal power supply overloaded.
► Pull the power plug of the device out of the
mains outlet.
► Wait fo
r abou t 3 minutes.
► Plug the power plug into a properly grounded
mains outlet again.
► Sw it
ch the device on.
Fujitsu 25
To Next Page
Loading...
