Fujitsu ESPRIMO P4 Series - Connecting keyboard and mouse

Getting started
Connecting a monitor
► Follow the instructions contained in the monitor manual to prepare the monitor
for operation (e.g . connecting cables).
Monitor
► Connect the data cable of the monitor into the monitor port of your device.
The optional monitor power cable may only be connected to the monitor socket of
the device if the monitor current consumption is less than 1 A with 240 V or 2 A
with 100 V. The values for the monitor current consumption can be found in the
technical data on the monitor or in the operating manual for the monitor.
► Plug the monitor power ca
ble into the grounded mains outlet.
Connecting the mouse
You can connect a USB mouse or a PS/2 mouse to your device.
Mouse,Connecting,
Connecting a USB mouse
► Connect the USB mouse to one of the USB ports on the device.
USBport,USBport
Connecting a PS/2 mouse
The PS/2 mouse is only detected by the device if you connect the mouse when
the device is switched off and then switch the device on again.
► Switch your dev
ice off.
If you do not at
tach a mouse to the PS/2 mouse port, you can disable the mouse
controller in
the BIOS Setup in order to free the IRQ12 for a different application.
► Connect the PS/2 mouse to the PS/2 mouse port of the device.
PS/2mouse,Connecting,PS/2mouse,
► Switch your device on again.
Fujitsu 15