System expansions
Do not throw away the slot co ver. For cooling, protection against fi re and in order to
comply with EMC regulations, you must refit the slot cover if yo u remove the board.
2
1
► Push the board in
to the slot (1).
► Tighten the screw on the slot cover (2).
► Secure the cove
r plate on the casing again.
► If necessary, connect th e cables to the board.
► Close the casi
ng (see "
Closing the casing", Page 32).
If you have in
stalled or removed a board, please check the releva nt PCI
slot setting
sintheBIOS Setup. If necessary, change the settings. Further
informatio
n is provided in the PCI bo ard documentation.
40 Fujitsu
To Next Page
Loading...
