Preparing for use
10 A26361-K1006-Z220-1-7619, edition 2
Connecting the keyboard
Depending on the equipment level selected, your device will be supplied with a USB keyboard or a
PS/2 keyboard.
Connecting a USB keyboard
Use the supplied keyboard cable only.
► Plug the rectangular connector of the keyboard cable into the rectangular socket on the
underside of the keyboard.
► Insert the flat rectangular USB plug of the keyboard cable into a USB port
of the device.
Connecting a PS/2 keyboard
Use the supplied keyboard cable only.
► Plug the rectangular connector of the keyboard cable into the rectangular socket on the
underside of the keyboard.
► Plug the round plug of the keyboard cable into the keyboard port
on the device.
Connecting external devices to the parallel or serial port
If your device has parallel and serial ports, you can connect external devices to these ports (such as
a printer or modem).
► Connect the data cable to the external device.
► Depending on the device, connect the data cable to the parallel port
or the serial port .
For an exact description of how to connect external devices to the corresponding port, please see
the external device documentation.
Port settings
i
You can change the port settings (e.g. address, interrupt) in the BIOS Setup (refer to the
Mainboard manual or the "BIOS Setup" manual.
Device drivers
i
The devices connected to the parallel or serial port require drivers. Your operating system
already includes many drivers. If the required drive is missing, install it. Current drivers are
usually available on the Internet or will be supplied on a data carrier.
To Next Page
Loading...
