System upgrades
48 A26361-K1006-Z220-1-7619, edition 2
Installing an accessible drive
► Open the casing (see "XOpening the casingX").
► If you are installing the drive in the upper bay and a cover (optional) is already in place, please
remove it.
!
Do not throw away the cover. For cooling, protection against fire, and in order to comply
with EMC (electromagnetic compatibility) regulations, you must refit the cover if you
remove the drive again later (see "
XRemoving an accessible driveX").
or
► If you are installing the drive in the lower bay, break out the pre-stamped metal panel on the
drive bay opening using a screwdriver.
► Adjust the required settings on the drive (also on drives which are already installed, if
necessary).
2
1
► Slide the accessible drive into the casing as far as the stop (1).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Fasten the screw (2).
► Close the casing (see "
XClosing the casingX").
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
To Next Page
Loading...
