System upgrades
A26361-K1006-Z220-1-7619, edition 2 45
Installing and removing optional ports
An additional port (serial or parallel) can be installed in a rear slot cover plate like a board. For an
exact description of how to connect external devices to ports, refer to the documentation for the
external device.
Installing an optional additional port
► Open the casing (see "XOpening the casingX").
1
2
► Press on the curved part of the retaining
clip (1).
► Remove the rear slot cover plate from the
slot (2).
!
Do not dispose of the cover plate. For cooling, protection against fire and in order to
comply with EMC regulations, you must refit the cover plate if you later remove the port.
2
1
► Push the port into the slot (1) as far as it will
go.
► Press the port into the slot until you feel it
engage.
► Press on the retaining clip until it you feel it
engage (2).
► Connect the cable of the additional port to the connector on the mainboard.
► Close the casing (see "
XClosing the casingX").
To Next Page
Loading...
