Fujitsu ESPRIMO P5635 - Indicators Provided by the Device

Preparing for use
A26361-K1006-Z220-1-7619, edition 2 13
Indicators provided by the device
The indicators are on the front of the casing. Which indicators are available on your device depends
on the configuration level you have selected.
3
1
4
2
1 = Drive indicator, e.g. DVD
2 = Floppy disk indicator
3 = Hard disk indicator
4 = Power-on indicator
Hard disk indicator
The indicator lights up when the hard disk drive of the device is accessed.
Power-on indicator
● The indicator lights up green:
The device is switched on.
● The display illuminates in orange or flashes green (depending on the type of device):
The device is in energy-saving mode. After being switched on with the power button, the device
switches on or returns to the state it was in before the energy-saving mode.
!
In an energy-saving mode the device must not be switched off with the main
power switch (if present) or disconnected from the mains, as this may result in
data loss.
● The indicator does not light up:
The device is switched off (power switch at 0 or disconnected from the mains) or ready. If the
device is ready it can be enabled with the ON/OFF switch.
Floppy disk indicator
The indicator lights up when the floppy disk drive of the device is accessed. You may only remove
the floppy disk when the indicator is unlit.
Drive indicator, e.g. DVD
The indicator lights up when the CD-ROM or DVD drive is accessed. You may only remove the
CD/DVD when the indicator is dark.