System upgrades
A26361-K1006-Z220-1-7619, edition 2 49
Installing and removing the floppy disk drive
► Open the casing (see "XOpening the casingX").
2
1
► Remove the data and power supply connectors from the floppy disk drive.
► Remove the screws (1) on the right side of the floppy disk drive.
► Slide the floppy disk drive out of the casing in the direction of the arrow (2).
► Slide the new floppy disk drive into the case opposite the direction of the arrow (2).
► Fasten the floppy disk drive with the screws (1).
► Fit the data and power supply connectors to the floppy disk drive. Make sure the polarity is
correct.
► Close the casing (see "
XClosing the casingX").
i
It may be necessary to modify the entry for the drive in the BIOS Setup.
To Next Page
Loading...
