Getting started
Fitting the base (optional)
Screw holes for attaching the b ase can only be found on the left side of the device.
1
2
2
1
3
4
4
3
► Place the devic
e on the right side as shown.
The screw holes (1) and guide openings (2) for securing the base on the
left side of the device are facing upward s.
► Place the base
on th e left side of the device such that the locking lugs (3) are inserted into the
correspondin
g guide openings (2) on the device and the screw holes (1 ) a nd (4) directly overlap.
► Place the screws into the overlapping screw holes (1 & 4) and attached
the base to the device using the screws.
24 Fujitsu
To Next Page
Loading...
