Getting started
Connecting external devices
Read the documentation o n the external device before connecting it.
With the exception of USB devices, always remove all power plugs
before connecting external devices!
Do not co nnect or disconnect cables during a thunderstorm.
Always hold the plug of a cable when removing it. Never unplug a
cable by pulling the cable itself.
To ensure that your device works properly, use only the connection cable
supplied or use a high-quality connection cable.
Ports on the device
PortsExternaldevicesDevice
The ports are located on the front and back of the device. The ports available on your
device depend on the configuration level you have selected. The standard ports are
marked with the symbols shown below (or similar). Detailed information on the location
of the connections is provided in the manual for the motherboard.
DVI-D monitor port, white
(device-dependent)
Monitorport
DP Display port
Serial port
Serialport
HDMI port (device -dependent)
USB 2.0 - Universal Serial
Bus, type A, black
UniversalSerialBus
LAN port
LANport
USB 3.1 Gen1 - U niversal
Serial Bus, Type A: blue, Type
C: black
UniversalSe
rialBus
Audio input (Line in, device-dependent)
USB 3.1 Gen2 - U niversal
Serial Bus, type A: blue, type
C: black
Audio output (Line Out,
device-dependent), light green
AudiooutputLineout
PS/2 keyboard port, purple
Keyboardport
Combined audio input and output
(device-dependent)
Some of the connected devices require special software (e.g. drivers) (refer to the
documentation for the connected device and Operating System).
34 Fujitsu
To Next Page
Loading...
