Getting started
Connecting the monitor
Connect the monitor to your device only if i t is switched off.
► Follow the instructions contained in the monito r operating m anual to prepare
the monitor ( e.g. connecting cables).
Monitor
► Plug the data cable into the desired monitor port of the device.
► Plug the m onitor power cable into the grounded mains outlet.
Connecting a USB mouse
► Connect the USB mouse to one of the USB ports on the device.
Connectinga USBmouseUSBport
Connecting a USB keyb
oard
Use the keyboard cable provided with the keyboard (not included in the delivery scope of the device).
USBportconnecting
► Plug the rectangular connector of the keyboard cable into the rectangular socket
on the underside or on the rear of the keyboard.
► Plug the flat rectan
gular USB connector of the keyboard cable into a USB port of the device.
USBport
Connecting external devices to the serial interface
SerialinterfaceSerialinterface,Externaldevices,Devices,
For an exact description of how to connect external devices to the corresponding
port, please see the external device documentation.
External devi
ces (e.g. a printer or scanner ) can be connected to the serial port.
► Connect the da
ta cable to the external device.
► Connect the data cable to the corresponding serial interface.
Port settin
gs
Serialinterface,
You can change the settings of the port in the BIO S Setup.
Device drivers
Devicedrive rs,
The devices connected to the serial interface require drivers. Your operating system
already includes many d rivers. If the required drive is missing, install it. The latest
drivers are usually available on the Internet or will be supplied on a data carrier.
Fujitsu 35
To Next Page
Loading...
