Fujitsu Eternus DX600 S3 - Package Size; Table 1.3 Package Size (for Regions Other than EMEA&I)

1.4 Package Size
The ETERNUS DX is shipped in cardboard boxes or in a rack. These boxes may not fit through some doorways
or elevators. To make sure that the ETERNUS DX can be moved to the installation site, carefully check the
transport route information.
The following table shows the package size and the maximum package weight of each component for re-
gions other than EMEA&I.
Table 1.3 Package Size (for Regions other than EMEA&I)
Component
Package size (W ´ D ´ H)
Maximum weight (approx.)
19-inch rack (base/expansion)
780 ´ 1,130 ´ 2,000mm
Approximately 1,000kg (*1)
Controller enclosure
600 ´ 950´ 285mm
Approximately 65kg
Drive enclosure 2.5" type
600 ´ 660 ´ 240mm
Approximately 40kg
3.5" type
600 ´ 660 ´ 240mm
Approximately 40kg
High-density type
640 ´ 1,115 ´ 625mm
Approximately 120kg
Drive (*2) 2.5" drive
160 ´ 278 ´ 106mm
Approximately 0.5kg
3.5" drive
189 ´ 300 ´ 116mm
Approximately 1.2kg
Power distribution unit 1U
570 ´ 710 ´ 160mm
Approximately 4kg
2U
(390´ 590 ´180mm) ´ 2 (Approximately 7kg) ´ 2
*1: This value is for when the maximum number of enclosures are installed in the rack.
*2: When an order for optional drives to be installed in the factory is placed, enclosures are shipped with
the drives preinstalled.
When optional drives are ordered without preinstallation, each drive is shipped in an individual pack-
age.
Chapter 1 ETERNUS DX Installation
1.4 Package Size
21
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Site Planning Guide
Copyright 2014 FUJITSU LIMITED
P3AM-7712-05ENZ0