Preface
Fujitsu would like to thank you for purchasing our FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage
system (hereinafter referred to as ETERNUS DX).
The ETERNUS DX is designed to be connected to Fujitsu servers (Fujitsu M10, PRIMEQUEST, or PRIMERGY) or
non-Fujitsu servers.
This manual describes the environmental requirements that are necessary to install and use the ETERNUS
DX.
This manual is intended for use of the ETERNUS DX in regions other than Japan.
Please carefully review the information outlined in this manual.
Fifth Edition
December 2014
About This Manual
Organization
This manual is composed of the following two chapters:
•
"Chapter 1 ETERNUS DX Installation" (page 11)
This chapter provides the installation specification of the ETERNUS DX.
•
"Chapter 2 Rack Installation Specifications" (page 37)
This chapter provides the installation specification of racks.
3
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Site Planning Guide
Copyright 2014 FUJITSU LIMITED
P3AM-7712-05ENZ0
To Next Page
Loading...
