Fujitsu Eternus DX600 S3 - Eternus Dx600 S3; Table 1.2 ETERNUS DX600 S3 Installation Specifications

*3: These values are measured when a single controller enclosure and four drive enclosures are configured
in an environment in which the temperature is 23 ± 2 °C.
1.1.2 ETERNUS DX600 S3
The following table shows the installation specifications of the ETERNUS DX600 S3.
Table 1.2 ETERNUS DX600 S3 Installation Specifications
Item ETERNUS DX600 S3
Dimensions
(W ´ D ´ H)
Controller enclosure
482 ´ 805 ´ 133mm (3U)
Drive enclosure 2.5" type
482 ´ 540 ´ 88mm (2U)
3.5" type
482 ´ 560 ´ 88mm (2U)
High-density
type
482 ´ 980 ´ 176mm (4U)
Power distribution unit 1U
435 ´ 148 ´ 38mm
2U
(485 ´ 280 ´ 43mm) ´ 2 (*1)
Maximum weight
(approx.)
Controller enclosure 54kg
Drive enclosure (*2) 2.5" type 35kg
3.5" type 35kg
High-density
type
95kg
Power distribution unit 1U 2kg
2U
(6kg) ´ 2 (*1)
Power Voltage AC 100 – 120V, AC 200 – 240V
Phase Single
Frequency 50Hz/60Hz
Maximum power
consumption
Controller enclosure AC 100 – 120V 720W (730VA)
AC 200 – 240V 1,000W (1,010VA)
Drive enclosure
(*2)
2.5" type AC 100 – 120V 430W (440VA)
AC 200 – 240V 430W (440VA)
3.5" type AC 100 – 120V 340W (350VA)
AC 200 – 240V 340W (350VA)
High-density
type
AC 100 – 120V 1,300W (1,320VA)
AC 200 – 240V 1,300W (1,320VA)
Maximum heat
generation
Controller enclosure AC 100 – 120V 2,600kJ/h
AC 200 – 240V 3,600kJ/h
Drive enclosure
(*2)
2.5" type AC 100 – 120V 1,600kJ/h
AC 200 – 240V 1,600kJ/h
3.5" type AC 100 – 120V 1,300kJ/h
AC 200 – 240V 1,300kJ/h
High-density
type
AC 100 – 120V 4,700kJ/h
AC 200 – 240V 4,700kJ/h
Chapter 1 ETERNUS DX Installation
1.1 Installation Specifications
13
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Site Planning Guide
Copyright 2014 FUJITSU LIMITED
P3AM-7712-05ENZ0