Fujitsu Eternus DX600 S3 - Figure 2.9 Connection Example 4 (ETERNUS DX600 S3 Connections in Multiple Racks)

● When Installing Enclosures in Multiple Racks
This section describes a connection configuration in which the enclosures are installed in multiple racks.
The following figure shows an example when one controller enclosure and twenty 2U drive enclosures are
distributed between two racks. Obtaining extra extension cables for these connections between the racks is
required.
Figure 2.9 Connection Example 4 (ETERNUS DX600 S3 Connections in Multiple Racks)
DE#13 (2U)
DE#03 (2U)
DE#32 (2U)
DE#22 (2U)
DE#12 (2U)
DE#02 (2U)
DE#31 (2U)
DE#21 (2U)
DE#11 (2U)
DE#01 (2U)
DE#30 (2U)
DE#20 (2U)
DE#10 (2U)
DE#00 (2U)
DE#34 (2U)
DE#24 (2U)
DE#14 (2U)
DE#04 (2U)
DE#33 (2U)
DE#23 (2U)
CE
Extension cables
6.0m
Chapter 2 Rack Installation Specifications
2.1 Rack Installation Requirements
47
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Site Planning Guide
Copyright 2014 FUJITSU LIMITED
P3AM-7712-05ENZ0