Fujitsu Eternus DX600 S3 - Installation Area; Figure 1.6 Installation Area and Service Area; Figure 1.7 Installation and Service Areas (When a High-Density Drive Enclosure Is Installed_1)

1.5 Installation Area
This section explains the installation areas and the service areas that are required for an ETERNUS DX that is
installed in a Fujitsu 19-inch rack.
Secure service areas that are 850mm or more in the front and rear of the ETERNUS DX.
To install a high-density drive enclosure, secure a service area that is 1200mm or more in front of the ETER-
NUS DX and a service area that is 850mm or more at the rear of the ETERNUS DX.
Figure 1.6 Installation Area and Service Area
850mm or more
850mm or more
ETERNUS DX
Rear service area
Front service area
Areas need to be secured temporarily around a rack to use a lifter to install a high-density drive enclosure in
the rack and perform maintenance work. When an area that is required to install a high-density drive enclo-
sure can be secured on the right side of the rack, refer to Figure 1.7. When an area that is required to install a
high-density drive enclosure can be secured in front of the rack, refer to Figure 1.8.
Figure 1.7 Installation and Service Areas (When a High-density Drive Enclosure is Installed_1)
850mm or more
1000mm
or more
1800mm or more
ETERNUS DX
Rear service area
Front service area
500mm or more
Chapter 1
ETERNUS DX Installation
1.5 Installation Area
22
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Site Planning Guide
Copyright 2014 FUJITSU LIMITED
P3AM-7712-05ENZ0