Fujitsu Eternus DX600 S3 - Figure 2.8 Connection Example 3 (ETERNUS DX600 S3 Connections in the same Rack)

● Installing 2U and 4U Drive Enclosures in the Same Rack
The following figure shows an example when one controller enclosure, two 4U high-density drive enclosures,
and six 2U drive enclosures are installed in the same rack.
For this type of configuration, obtaining extra extension cables to connect 4U drive enclosures and 2U drive
enclosures is required. Extra extension cables are also needed for reverse cabling.
Figure 2.8 Connection Example 3 (ETERNUS DX600 S3 Connections in the Same Rack)
DE#00 (4U)
CE
DE#10 (4U)
DE#31 (2U)
DE#21 (2U)
DE# 11 (2U)
DE#01 (2U)
DE#30 (2U)
DE#20 (2U)
Cables that are supplied as standard
1.1m
3.5m
Extension cables
3.5m
Chapter 2 Rack Installation Specifications
2.1 Rack Installation Requirements
46
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Site Planning Guide
Copyright 2014 FUJITSU LIMITED
P3AM-7712-05ENZ0