Fujitsu Eternus DX80 S2 - E-Mail Setup

Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
120
5.2.2 E-mail Setup
If an event occurs in the ETERNUS DX Disk storage system, the event information is reported to the specified e-
mail address.
The e-mail setting is explained below.
Procedure
1 Start ETERNUS Web GUI.
2 On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
3 In [Category], click [Network].
The [Basic] tab screen of the [Network] screen appears.
4 In [Action], click [Setup E-Mail Notification].
The [Notification E-Mail] tab screen of the [Setup E-Mail Notification] screen appears.
5 In the [Notification E-Mail] tab screen, set the following items:
• Select "Yes" for "Notification E-Mail".
• Enter the destination e-mail address or addresses for the Destination E-Mail Address fields.
6 Click the [Mail Server Settings] tab.
The [Mail Server Settings] tab screen appears.
• Up to five e-mail addresses can be set.
• Make sure to check whether the e-mail messages are received correctly after the e-mail notification
environment setup is complete.
• E-mail messages are not sent again when a communication error occurs between the ETERNUS DX Disk
storage system and the SMTP server.