Fujitsu Eternus DX80 S2 - Drive Enclosure Connection

Chapter 4 Connecting Cables
4.3 Drive Enclosure Connection
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
73
2 Connect the miniSAS cables to the connection destination.
Connect the connector at the other end of the miniSAS cable to the connection destination.
End of procedure
4.3 Drive Enclosure Connection
When a Drive Enclosure is installed, connect the Drive Enclosure to the Controller Enclosure with a QSFP cable.
When multiple drive enclosures are installed, connect the drive enclosures with QSFP cables.
Two QSFP cables (75cm) are supplied with each drive enclosure dual-IOM type, and one QSFP cable (75cm)
with each drive enclosure single-IOM type.
The following procedure explains how to connect the QSFP cable.
CAUTION
Do
• When connecting the miniSAS cables, position them so that they will
not obstruct replacement of the power supply unit or controllers by the
maintenance engineer.
• To help with QSFP cable management and prevent incorrect connections, make sure to attach the
destination labels that are supplied with the ETERNUS DX Disk storage system to the connectors of the
QSFP cables.
• When connecting QSFP cables, check the connector orientation and then firmly push it all the way in.
When disconnecting QSFP cables, use the pull-tab to extract the connector.
Tab