Fujitsu Eternus DX80 S2 - Installing Drive Enclosure

Chapter 3 Rack Installation
3.3 Installing Drive Enclosure
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
58
3.3 Installing Drive Enclosure
This section describes how to install a drive enclosure in a rack.
CAUTION
Do Not
• Do not uninstall the drives that are installed by default or move them to any
other slot.
Contact your sales representative or maintenance engineer if drives that are
installed by default need to be uninstalled or moved to another slot.
Drive enclosures must be installed above the controller enclosure. When installing multiple drive enclosures,
install them in the order of the "DE_No. label" numbers that are attached to the drive enclosures.
The DE_No. labels are attached on the following locations.
Right front side of the drive enclosure Upper rear side of the drive enclosure
DE_No. label