Fujitsu Eternus DX80 S2 - Table 1.2 LAN Port Availability

Chapter 1 Preparation
1.1 Connection Preparation
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
23
1.1.2.3 Notes on LAN Connection
■ Network communication protocols
The usable LAN ports and functions are different depending on the usage and protocol.
The following table shows how the LAN ports may be used (by usage and protocol).
Table 1.2 LAN port availability
Yes: Available / No: Not available
Usage Protocol
tcp /
udp
Port
number
Direction
Master CM Slave CM
Remarks
MNT RMT MNT RMT
ETERNUS Web
GUI
http /
https
tcp 80 / 443 from Yes Yes *1 *1 Accessed from a
Web browser
ETERNUS CLI telnet /
ssh
tcp 23 / 22 from Yes Yes *1 *1 —
ftp
(client)
tcp 21 to Yes Yes *1 *1 —
SNMP agent snmp udp 161 from Yes Yes Yes Yes —
trap snmp
trap
udp Must be
set
to Yes
(*2)
Yes
(*2)
No No —
SMI-S http /
https
tcp 5988 /
5989
from Yes No No No Used for SMI-S
client
communication
E-mail smtp
(client)
tcp 25 (*3) to Yes
(*2)
Yes
(*2)
No No Used for failure
notification, etc.
NTP NTP udp 123 to Yes
(*2)
Yes
(*2)
No No —
REMCS
(remote
support)
smtp tcp Must be
set
to Yes
(*2)
Yes
(*2)
No No Used for failure
notification, etc.
http
(client)
tcp Must be
set
to Yes
(*2)
Yes
(*2)
No No Used for
firmware
download, etc.
AIS Connect
(remote
support)
https
(client)
tcp 443 to Yes
(*2)
Yes
(*2)
No No —
syslog
(event
notification and
audit log
sending)
syslog udp Must be
set
to Yes
(*2)
Yes
(*2)
No No —
RADIUS Radius udp Must be
set
to Yes
(*2)
Yes
(*2)
No No —
ping ICMP — — from Yes
(*2)
Yes
(*2)
No No —
KMIP
(key
management )
SSL tcp 5696 (*3) to Yes
(*2)
Yes
(*2)
No No —