Chapter 4 Connecting Cables
4.2 Host Interface Connection
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
68
1 Remove the connector covers that are attached to the host interface ports (FC, iSCSI 10Gbit/
s, or FCoE) of Controller 0 (CM#0) and Controller 1 (CM#1).
2 Connect the FC cable to the ETERNUS DX Disk storage system.
2-1 Remove the covers from the FC cable connectors.
2-2 Insert the FC cable connectors in the host interface ports (FC, iSCSI 10Gbit/s, or FCoE) of Controller 0
(CM#0) and Controller 1 (CM#1).
Keep the removed connector covers in a safe place where they will not be lost.
• When connecting the FC cables, position them so that they will not
obstruct replacement of the power supply unit or controllers by the
maintenance engineer.
To Next Page
Loading...
