fi-5120C / fi-5220C Image Scanner Operator
Guide
TROUBLE SHOOTING
CONTENTS MAP
TOP
5.3 Replacing the Pick Roller (2)
1
2
3 4
5. Remove the Pick roller from the shaft while lifting up the tab on the Pick roller.
Pull out the shaft from the pick roller while lifting up its tab.
ATTENTION
If you push up the pick roller tab using your fingernail, it may heart
or get chipped your fingernail. If you worry about that, you push up
the pick roller tab using a paper clip.
6. Attach the new Pick roller.
Insert the new Pick roller aligning the protrusion on the shaft with the slot for the screw in the Pick roller.
: Pick Roller Shaft
: Protusion
: Pick Roller
ATTENTION
Make sure that the Pick roller is completely attached. An incompletely
attached Pick roller might cause document jams or other feedings errors.
1
2
3 4
All Rights Reserved Copyright 2006-2009 © PFU LIMITED
To Next Page
Loading...
