fi-5120C / fi-5220C Image Scanner Operator
Guide
TROUBLE SHOOTING
CONTENTS MAP
TOP
3.8 Skipping blank pages (2)
1
2
3. Check the [Blank Page Skip] box.
If an item other than "Ram cache" or "Use Both Memory" has been selected in the [Cache Mode:] and this check box is
marked, it will change to "Ram cache".
4. With the slider control under [Blank Page Skip], specify the Blank Page Skip degree.
In Binary/Halftone mode
For white pages, use the [Black Dots Ratio] slider bar to set the skip condition. For black pages, use the [White Dots
Ratio] scroll bar to set the skip condition.
The value displayed to the right of the scroll bar displays the noise ratio(*1). If a scanned document is below this value, it
is recognized as a blank page. The setting range is OFF(- -) and 0.2% to 3.0% (in increments of 0.2%).
*1: Ratio of black dots included in the scanning area. (for white pages)
In Color/Grayscale mode
Use the slider bar to set the skip condition in five stages from 1 to 5. To make the blank pages easy to skip, increase the
value of the setting.
1
2
All Rights Reserved Copyright 2006-2009 © PFU LIMITED
To Next Page
Loading...
