Network Scanner fi-6000NS Getting Started xi
CAUTION
Do not install the scanner on unstable
surfaces.
Do not block the ventilation ports.
Do not place heavy objects or climb on
top of the scanner.
Firmly insert the power plug.
Avoid any contact when scanner is in use.
Do not use the scanner immediately after
moving it from a cold place into a warm
room.
Before moving the scanner, disconnect
the power plug from the power outlet.
Protect the scanner from static electricity.
Do not use aerosol sprays near the
scanner.
Disconnect the power plug from the
power outlet when the scanner is not used
for a long period of time.
Do not install the scanner in the direct
sunlight.
Before moving the scanner, make sure the
shipping lock is locked.
Make sure that the scanner is installed on a
flat, level surface and that none of its parts
extend beyond the surface top, such as a
desk or table. Do not install the scanner on
unstable surfaces. Install the scanner on a
level surface that is free of vibration to
prevent it from falling.
Install the scanner on a strong surface that
will support the weight of the scanner and
other devices.
Do not block the ventilation ports. Blocking
the ventilation ports generates heat inside
of scanner, which may result in fire or
scanner failure.
Do not place heavy objects on the scanner
or use the scanner's surface top to perform
other work. Improper installation might
cause injuries and equipment failure.
Firmly insert the power plug as far it can go
into the power outlet.
Avoid touching any scanner mechanism
during scanning since this may cause
injuries.
Do not use the device immediately after
moving it from a cold place into a warm
room. Condensation may occur, which
might lead to scanning errors. Let the
device dry about one or two hours before
you use it.
Do not move the scanner with the power
and interface cables connected as this can
damage the cables, which can later cause
fire, electric shock as well as injury.
Before moving the scanner, be sure to
disconnect the power plug from the power
outlet, and all other data cables.
Make sure that the floor is free of any
obstructions.
Install the scanner away from strong
magnetic fields and other sources of
electronic noise. Also, protect the scanner
against any static electricity, which can
cause the scanner to malfunction.
Do not use aerosol sprays to clean the
scanner. Aerosol sprays can blow dirt and
dust inside the scanner, resulting in scanner
failure or malfunction.
When the scanner is not going to be used
for a long period of time, be sure to
disconnect the power plug from the power
outlet for safety.
Do not install the scanner under direct
sunlight or near heating apparatus. Doing
so might cause excessive heat to build up
inside the scanner, which can cause
scanner trouble or even fire. Install the
scanner in a well-ventilated location.
When moving the scanner, be sure to lock
the shipping lock in order to prevent
damages to the scanner.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
