Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
128
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
■Transport Lock, Cover Open, and Print Errors
Error codes beginning with the letter "U" are displayed.
*1: When you open the ADF while the scanner is in standby, only an error
message will appear without an error code.
Also, note that buttons on the operator panel are disabled while the
ADF is open.
*2: When you open the imprinter print section while the scanner is in
standby, only an error message will appear without an error code.
Also, note that buttons on the operator panel are disabled while the
imprinter print section is open.
*3: Displayed when the imprinter is installed.
Device Errors
The following are lists of device errors which require
troubleshooting by a service engineer.
■Internal and Optical Errors
Error codes beginning with the letter "E" are displayed.
Error
code
Error messages Action
U0:10 Transport lock
error
Unlock the
transport lock
switch.
[fi-7700/fi-7700S]
Unlock the transport lock.
For details, refer to the Quick Installation
Sheet.
U4:40
(*1)
ADF open Close the ADF and reload the
documents.
U5:4A
(*2)
(*3)
Imprinter Cover
Open
Close the print section of the imprinter,
and load the document again.
U6:B4
(*3)
Print cartridge not
installed
Check if the Print
Cartridge is
mounted
correctly.
This error is related to the imprinter.
For details, refer to the fi-760PRB
Imprinter Operator's Guide.
U7:B9
(*3)
Imprinting area
error
Adjust the imprinting start position and
the imprinter strings to fit the imprinting
area in the document.
For details, refer to the fi-760PRB
Imprinter Operator's Guide.
Error
code
Error messages Action
E0:87 FB carrier error
Unlock the transport
lock switch.
[fi-7700/fi-7700S]
Unlock the transport lock.
For details, refer to the Quick
Installation Sheet.
E1:7E Optical error (FB)
If the problem persists
after turning the power
back on, please inform
your service provider
of the above error
code.
[fi-7700/fi-7700S]
1 Check whether the transport lock
is unlocked.
For details, refer to the Quick
Installation Sheet.
2 Turn the scanner off then back on.
If the problem persists, write
down the displayed error code
and contact your FUJITSU
scanner dealer or an authorized
FUJITSU scanner service
provider.
To Next Page
Loading...
