Fujitsu FI-7600 - Installing the ADF Paper Chute (Feeder) and the Stacker

How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Appendix
Appendix
Glossary
Introduction
Index
Contents
220
How to Load
Documents
Scanner
Overview
TOP
Installing the ADF Paper Chute (Feeder) and the
Stacker
The procedure to install the ADF paper chute (feeder) and the
stacker after opening the package for the scanner is as
follows:
For details about how to connect the scanner to the computer,
refer to the Quick Installation Sheet.
1 Install the ADF paper chute (feeder) and the
stacker.
Install the stacker in the following procedure:
1 Insert the protrusion on the right side of the stacker into the slot
and then push the left side of the stacker along the slot in
the direction of the arrow.
ADF Paper Chute
(Feeder)
Stacker
1
2
1
2