Fujitsu FI-7600 - Shortening the Scanning Intervals [Pre-Pick]

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
182
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
2 From the listing on the left, select [Device Setting 2] 
[Dropout color].
3 Select a color to drop out.
Red, Green, Blue, White: The selected color is dropped out.
None: No color is dropped out.
Shortening the Scanning Intervals [Pre-Pick]
"Pre-pick" refers to feeding the document to the starting
position for scanning before the next scan.
Enabling [Pre-Pick] shortens the interval between scanning
each document.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 156).
2 From the listing on the left, select [Device Setting 2] 
[Pre-Pick].
ATTENTION
The Software Operation Panel allows you to choose the color from
red, green, blue, and white only. To drop out other colors, configure
the setting in the scanner driver.
For details, refer to the scanner driver's Help.
HINT
This setting can also be configured in the scanner driver. Note that
priority is given to the scanner driver setting.