Fujitsu FI-7600 - Scanning a Book [Fi-7700;Fi-7700 S]

Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
89
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
How to Use the
Operator Panel
Scanning a Book [fi-7700/fi-7700S]
1 Open the document cover.
For details, refer to "1.5 Opening/Closing the Document Cover [fi-
7700/fi-7700S]" (page 25).
2 Place a document on the document bed.
Place the document face-down to align its top left-hand corner with
the reference point.
3 Gently close the document cover.
For details, refer to "1.5 Opening/Closing the Document Cover [fi-
7700/fi-7700S]" (page 25).
4 In the scanner driver, configure the scan settings for using
the flatbed.
For details, refer to the scanner driver's Help.
5 Scan the document with the image scanning application.
For details, refer to the image scanning application manual.
ATTENTION
Note that a curled or folded document may create a small gap
between the document and the document bed, causing the
scanned image to be blurred.
Reference
Point
HINT
 A document can be scanned with the document cover open.
For details, refer to " Scanning Documents with the Document
Cover Open [fi-7700/fi-7700S]" (page 96)
 To scan documents on a black background, use an optional
black document pad (sold separately).
For details about the black document pad, refer to "A.4
Scanner Options" (page 215).