Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
176
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Scanner Cleaning Cycle [Cleaning Cycle]
The cleaning cycle for the scanner can be specified.
The background color of the counter after cleaning in [Device
Setting] turns yellow when the sheet count after cleaning is
performed reaches the specified value.
You can also display a cleaning instruction message (page 175).
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 156).
2 From the listing on the left, select [Device Setting 2]
[Cleaning Cycle].
3 Specify a value for the cleaning cycle.
The value can range from 1,000 to 255,000 sheets (in increments of
1,000).
Specify whether or not to display the cleaning instruction message.
Replacement Cycle of Consumables [Life
Counter Alarm Setting]
The replacement cycle for each consumable can be specified.
The background color of the brake roller/pick roller counter in
[Device Setting] changes to light yellow when the sheet count
after a consumable replacement reaches 95% of the value
specified here, and turns yellow when the sheet count reaches
100%.
You can also display the message for replacing consumables
(page 175).
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 156).
2 From the listing on the left, select [Device Setting 2]
[Life Counter Alarm Setting].
To Next Page
Loading...
