Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
183
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
3 Specify whether or not to enable pre-pick.
Select [Yes] or [No].
Number of Paper Feeding Retries
Configure this setting to change the number of feeding retries
when a pick error occurs.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 156).
2 From the listing on the left, select [Device Setting 2]
[Number of paper feeding retries].
3 Specify the number of paper feeding retries.
The value can range from 1 to 12 times.
HINT
If you cancel in the middle of scanning while pre-pick is
enabled, you will have to remove the pre-picked document,
then load the document again.
This setting can also be configured in the scanner driver or with
the operator panel. Note that priority is given to the scanner
driver setting.
HINT
This setting can also be configured with the operator panel.
To Next Page
Loading...
