Fujitsu FI-7600 - Operational Settings; Quality of Scanned Text or Lines Is Unsatisfactory

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
140
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
Quality of scanned text or lines is unsatisfactory.
*1: When you scan in grayscale or in color mode, the scanned image may not become sharp and clear.
ADF:
Are the glass and rollers inside the ADF clean?
Flatbed [fi-7700/fi-7700S]:
Are the document pad and the document bed clean?
No
Clean the dirty parts.
For details, refer to "Chapter 5 Daily Care" (page 102).
Yes
Is the resolution appropriate?
No
Specify a higher resolution in the scanner driver.
Yes
Did you configure the settings in the scanner driver to scan
in grayscale or color mode?
Yes
Configure the settings in the scanner driver to scan in black & white mode. (*1)
No
Is there any foreign matter (such as dust or paper dust) on
the document?
Yes
Remove any foreign matter off the document.
Foreign matter may get on the glass that is inside the ADF or the document bed of
the flatbed [fi-7700/fi-7700S], and cause the image to appear dirty.
No
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 152) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.